Arduino Mega to GSM GPS RFID

$30-250 USD

W trakcie realizacji

Opublikowano

prawie 11 lat temu

$30-250 USD

Płatne przy odbiorze

Need a programmer to generate a code to get the uplaod of GPS data thru GPRS at a set interval, configured by sms and TCP (Gprs). Also to save each data in SD card. When RF card is shown to RFID it should upload the data captured with GPS time thru gprs. also save each data to sd card with a serial number and if instructed device should send the backlog data thru gprs. Sms command: IP and Port, Time interval, APN, Identity of device, turn digital pin high/low Gprs packet :imei, gprmc,with 5 Digital input pin status and 2 Analog pin I have the Arduino Mega Board with GSM 900a modem and GPS with RFID. You need to give me connectivity diagram and with source of the project as required above. Experience in Arduino will be preferred, also with time faster

C Programming

Embedded Software

Engineering

Identyfikator projektu: 4546393

Informację o projekcie

2 ofert

Zdalny projekt

Aktywny 11 lat temu

Szukasz sposobu na zarobienie pieniędzy?

Adres e-mail

Korzyści ze składania ofert na Freelancer.com

Ustal budżet i ramy czasowe

Otrzymuj wynagrodzenie za swoją pracę

Przedstaw swoją propozycję

Rejestracja i składanie ofert jest bezpłatne

Przyznano:

@ajay88

Hello, Having looked at the brief project requirements, I think I can take this up. This is because I have got prior experience in handling Arduino boards with ATMega328 and I have also worked on a few 8, 16 and 32 bit micro-controllers. With respect to GPS and GPRS, I have handled them at my previous work to actually get the information from gps and send present location to a recipient through mobile data. To send SMS, i have handled GSM modem uding AT commands on a home automation project. Hopefully, with all these knowledge, I believe strongly I would be able to finish this job for you. For your reference you can look at my CV/ Resume Thanks

$166 USD w 6 dni