I would like to hire a Coder - 18/01/2017 15:03 EST

I have a hydraulic press that is being controlled in two ways, the motor and the ventile. The valve is being controlled by an electromagnet when the electromagnet is on, you can push the handle of the puncher on the electromagnet. Now the valve is open and when the motor is on the hydraulic pusher starts moving. When it reaches a sensor the electromagnet is turned off. I would like you to program another two buttons; one that turns the motor off for just a little amount of time and another button that is the emergency stop this button will put the electromagnet of when it is pressed just like the sensor. Pls note the sensor and the emergency stop are only supposed to be turned off when the electromagnet is pressed after it is pressed the electromagnet should be on I would like to have it before Friday. Thanks a lot Omar Tabbaa This is the code I wrote It has mistakes and it has no emergency stop If you could make one code without emergency stop and one with that be great I would like to have it done as soon as possible I hope you can send it to me tomorrow because I need it on Friday morning. int moterRelaiPin = 2; int switchsensorPin = 4 ; int buttonmotorpush = 7; int electromagnet = 8; int buttonmotorof = 12; int bottons; int stoppen = 0; void setup () { pinMode(moterRelaiPin, OUTPUT); pinMode(switchsensorPin, INPUT); pinMode(buttonmotorpush, INPUT); pinMode(electromagnet, OUTPUT); pinMode(buttonmotorof, INPUT); } void loop () { stoppen = digitalRead(switchsensorPin); digitalWrite(electromagnet, stoppen); { switch (bottons) { case 0: digitalRead(buttonmotorpush, HIGH); delay(50); digitalWrite(moterRelaiPin, HIGH); break; case 1: digitalRead(buttonmotorof, HIGH); delay(50); digitalWrite(moterRelaiPin, LOW); delay(500); digitalWrite(moterRelaiPin, HIGH); break; }