mikroC or mikroBasic code programming needed for PIC Microcontroller

(Do NOT bid for the project if you are not able to show sample of below code)

I need a working code to be written into PIC Microcontroller family where a crystal of 12MHz is being used.

It is a device that will detect object using IR sensor with 4 indicator LEDs.

It has a USB plug where data will be sent to and received from PC.

I have a program which will send command to the PIC so it will generate some function.

LED startup signal: LED1 on, wait 1 sec, LED2 on, wait 1 sec, LED3 on, wait 1 sec, LED4 on

LED standby signal: 0.5 sec Flip Flop of LED1+LED3 and LED2+LED4. (LED1+LED3 on, LED1+LED3 off, LED2+LED4 on, LED2+LED4 off, etc.)

LED active signal: 0.5 sec blinking of LED1+LED2+LED3+LED4 (LED1+LED2+LED3+LED4 on, LED1+LED2+LED3+LED4 off, LED1+LED2+LED3+LED4 on, etc.)

LED hold signal: LED1+LED2+LED3+LED4 on (persistently).

This is what it shall do when the device is plugged into PC (initial action without send/receive data from/to PC):

1. PC shall detect the device/hardware once plugged in. It shall display device name (e.g. "PIC Object Sensor").

2. It shall starting to send "LED startup signal".

3. Start IR sensor detection. (When there is no object, "LED hold signal" is activated. And when there is an object, "LED standby signal" is activated)

Function for receiving/sending data from/to PC :

1. If it receive code (e.g. !0001A), activate "LED standby signal". No data to be send to PC.

2. If it receive code (e.g. !0002A), activate "LED hold signal". No data to be send to PC.

3. If it receive code (e.g. !0002A), activate "LED active signal". No data to be send to PC.

4. If it receive code (e.g. !0088A), activate "LED hold signal" and start IR sensor detection for unlimited time. (When there is no object, "LED hold signal" is activated. And when there is an object, "LED standby signal" is

activated). No data to be send to PC.

5. If it receive code (e.g. !00AAA), activate "LED standby signal" and start IR sensor detection for unlimited time. (When there is no object, "LED standby signal" is activated and send data to PC (e.g. 1B2F1022BBA1FF). And when there is an object, "LED active signal" is activated and send data to PC (e.g. 2B3F003D1FFAA0)).

Basically it is a simple code if you know what you are doing.

I am using PIC Microcontroller (microchip) only, thus do NOT offer me code in ATmega, PLC, Arduino, Raspberry Pi, etc.

I have a tight budget of 25 EUR only.

To prove that you able to do it, please send me the code in mikroC/mikroBasic or the hex code when I'll contact you through chat for above sample function and PIC number.

So, don't simple bid for the project if you are not able to show me above working sample.

I will give a full detail of the project which contains approximately 8 similar functions.

I will award this project to the right person only after I check the sample code.

The full code (including hex code) shall be submitted upon project completion.

Elektronika Mikrokontroler Programowanie C Inżynieria elektryczna

Numer ID Projektu: #27310730

O projekcie