Hi, I currently need assistance with setting up and configuring a STM32F103VET6 MCU Board which will be flashed via a 20 pin JTAG port by a ULINK2 device using Keil uVision4 as the IDE.
Hi. I am hardware engineer. I'm working with Altium Designer, KEIL, IAR, GCC, MCU like AVR, ARM7, Cortex, Blackfin DSP. I have experience of developing circuit diagram, PCB and software for STM32F105RCT6. I am using KEIL and also RTX RTOS.
Hi, I designed few products using a similar setup (STM32 F-1 w/ STM32F103 and STM32 F-2 w/ STM32F207IGH6) with uVision 4.
I used uLink Pro to flash/debug using both JTAG and SW interfaces.
Hi I am a computer engineer and have expertise on the design and development of embedded systems. I had developed different embedded systems including USB based PIC micro development kit, Robotic arm control system, GSM based remote weather station and many more. As I am new to odesk so really looking for improving my profile with good feedbacks
I am a electronic engineer.I am familiar with stm32F103R8?stm32F103ZE?stm32F207ZG related progams which will be flashed via a 20 pin JTAG port by a jlink device using Keil uVision4 (4.12)as the IDE. I am familiar with ULINK2 too.