an arduino based kettle (with temp reader and 2 servos)

Hello freelancers I need coder for my arduino i want to connect a thermostat(for measuring purposes) and 2 servos(one linear, one rotary) and a relay(for the kettle or a boiler) plus two buttons(for control purposes) First button will start the following: 1-the kettle will start heating the water by connecting the relay 2-the termostat to read the temp of the water, if it reached (98 degree Celisse) it turn the relay off and turn a the 1st servo (rotary one) to +90 and back to neutral statues and the 2nd servo (linear one) to down mode 3-Then after the water cools down (85 degree Celisse) the relay turns on 4-After that, if the water reached (96 degree Celisse), the 2nd servo (linear one) goes up to the neutral statues and the 1st servo (rotary one) goes to -90(opposite angel) and back again to neutral statues and the relay turn off Second button the second button will be used only for heating till the water reaches (89 degree Celisse) i be using an arduino UNO and a Bread board and the off the shelf water boiler, plus a Waterproof (DS18B20) Temperature Sensor, the linear servo is a 2.3-Gram Performance Linear Long Throw Servo, the rotary servo is a Micro Servo g9 A0090 and the relay is a JZC-11F 5VDC 220V AC5A(if it can handle the power) what i want is: a diagram scheme and the code for the arduino and a go through coaching to make it thank you PS I made it a sealed bid, so put a good price :)