modify Solar MPPT Charger pcb and pic micro. code

Hi, I am electrical engineer, I have also completed Master in electrical engineering, with specialization in power electronics. I have done research on the topic in master thesis, title as "Modeling and Control of the interleaved Converters for Grid-Connected Photovoltaic Systems." I have gone through your requirements and attached research paper. I have to just change the type of MPPT algorithms from P&O to linear QUADRATIC controller. I have written three research papers on my thesis. Two are submitted for review and one under process. One of the two is submitted in IEEE Transaction on power electronics. My thesis covered following major aspects. 1. Brief introduction and benefits of Interleaving. 2. System modelling and control structure. 3. Literature review of single loop control strategy. 4. Performance of proposed strategy. 5. Optimization of controller. 6. Optimization of Filter. 7. Simulation results Simulation under robust conditions specified by IEEE 1547 On PV side I worked on : (i) Converter design for PV system. (ii) MPPT Tracker using Perturb Observe algo (iii) Charge Controller for PV system. (iv) Three phase H-bridge using IR series (v) Inverter and converter design along with SOLAR PV SYSTEM DESIGN vi. Load estimation vii. Estimation of number of PV panels viii. Estimation of battery bank ix. Cost estimation of the system 2. I also has high expertise in c programming of micro-controllers. I also provide professional services for embedded system programming. 3. So, i am interested in your project of ********************************************************************************************************************************* Design of Maximum Power Point Tracking Regulator for Solar Photo-Voltaic System ********************************************************************************************************************************* Your Thesis simulation is close inline with my thesis, so i am bidding on your project. I will simulate your project and will produce your required results in minimum time. I am expert in Simulink simulations specially, related to electrical engineering Waiting for your invitation. Thank you.

No need of all HW ckt's. One Micro, PWM driver ckt and Lcd is required.. All ready I impleted 6 stage charging algorithm.

I have very good PCB designing skills and good programmer in C.

I've worked in a graduated project, part of it is similar to your project description. So, I'm ready to achieve your requirements.