I need some Graphic Design for a roller banner and step-and-repeat board

I need two designs mocked up, one for a roller banner, one for a step-and-repeat board. Roller banner size 800mm x2100mm Step and repeat board size 1500mm x 2000mm The roller banners specs are: File type - files should be supplied as high resolution (high quality) 300dpi PDFs. Images - all images used during artwork preparation should be 300dpi at the Finished Print Size to ensure good quality print. Fonts - all fonts should be embedded (select embed fonts in distiller options) or converted to curves. Colour pallette - please supply as a CMYK PDF, not RGB. It is important to ensure that all images used are also converted to CMYK. Using RGB PDFs can cause incorrect colours being printed or faults with RGB images. Bleed - PDFs need to be supplied with 3mm bleed and trim marks. With roller banners it is important to take into account the area that will stay in the stand at the bottom of the panel. This area should also be treated as bleed. Spot colours - all spot colours need to be converted to CMYK before creating the PDF. If the PDF is set up with spot colours these will be converted before printing and may cause incorrect colour reproduction. The bottom 100mm of the banner material stays within the Roller Banner mechanism at the bottom of the banner and won't be seen. Please bear this in mind when setting up your artwork as it must be set up to the correct size. The print ready PDF must be at least 300dpi with a 3mm bleed if appropriate. It's fine to set the artwork up at 1/2 or 1/4 size as long as the dpi remains 300 at full size. I've attached two mocked up designs.